RAM Audio S 1500 DSP- PA Power Amplifier 2x 880 W + DSP
AH-RAMS1500DSP
2x 800W/rms
excl Verzendkosten kg
    Levertijd:3-5 dagen
Bestel
  • Beschrijving
  • Meer

RAM Audio S 1500 DSP - PA Power Amplifier 2x 880 W 2- Ohms incl. DSP Module

Compact 2 and 4-channel Power Amplifiers with state-of-the-art QuantaPulse EVO SMPS
The state-of-the-art QuantaPulse EVO switched-mode power supply of the new S Series amplifiers provides major benefits: it increases efficiency and reliability, generates less heat and keeps the weight down. While delivering high output power S series amplifiers tip the scales at around 8 kg only.

S Series power amplifiers are available with 2 and 4 channels and output ratings from 1.5 to 6 kW. Housed in 30 cm deep, 2U rackmountable chassis the S series uses surface-mount technology with high component density for maximum reliability.

Main Features
QuantaPulse™ EVO switched-mode power supply for maximum efficiency, increased output and reliability
five 2-channel models with up to 4 kW output power
very light weight (8 kg), 2U and 30 cm depth
electronic protection circuits
high component density surface-mount technology (SMT) provides mechanical strength and reliable operation
Neutrik XLR and Speakon connectors
QuantaPulse™ Technology: The Soft Switching Resonant QuantaPulse Power Supply is designed to provide plenty of power when needed monitoring the necessary parameters of voltage and current for a controlled performance at all times. Bi-directional data flow between the power supply and power amp module. Two very important characteristics of the QuantaPulse power supply are the optimization against over-voltages and superior reliability.

Technical Specifications:

Product type: Power amplifier RAMS1500
Type: 2-channel
Output power (1 kHz  2 ohms): 2 x 880 W
Output power (1 kHz  4 ohms): 2 x 575 W
Output power (1 kHz  8 ohms): 2 x 325 W
Output power (1 kHz  4 ohms, bridged mode): 1760 W
Output power (1 kHz  8 ohms, bridged mode): 1150 W
High Z (100Vrms / 140Vpeak) 1x1140 W
Circuit concept: Class H
Frequency response: 20 - 20,000 Hz
THD: < 0,05 %
S/N ratio: 112 dB
Damping Factor: > 500
Crosstalk: > 75 dB
Voltage gain: 26 dB / 32 dB / 38 dB
Input sensitivity: 2.6 dB/ 1.3 dB/ 0.6dB
Input impedance: unbalanced 10 kohms, balanced 20 kohms
Protection: Soft start, power on/off transients, power on muting, overheating, DC voltage, high frequency, short circuit, open outputs, mismatching
Controls: Power, 2 x volume, dual/bridge switch
Indicators: Clipping, ready, signal, temperature, fault
Line input connectors: 2 x XLR
Line output connectors: 2 x XLR
Speaker output connections: 2 x Speakon
Cooling system: fan
Power supply: 230 V
Power consumption  full load: 4.0 A
Width: 483 mm
Height: 89 mm
Depth: 310 mm
Product category: extension module RAMDSP22S
Type: digital signal processor
Channels: 2
AD/DA conversion: 24-bit
Sampling rate: 192 kHz (256x oversampling)
Filter types: Butterworth, Bessel, Linkwitz-Riley
Filter slope: up to 48 dB/octave
Output EQ: 9 filters (parametric, shelving, LP, HP, BP, SB) each channel
Output Delay: up to 7.1 m (20.69 ms) each channel
Limiter: RMS Power, Peak Voltage Output each channel
Additionakl DSP functions: Gain, Mute, Phase Inversion each channel
Line inputs: 2
Line input connectors: XLR balanced
Line outputs: 2
Line output connectors: XLR balanced
Programming: via USB port